Science-fiction writer Jules Verne predicted many scientific breakthroughs, including the moon landing, tasers, and nuclear submarines. In his 1874 book The Mysterious Island, Verne writes:
I believe that water will one day be employed as fuel, that hydrogen and oxygen which constitute it, used singly or together, will furnish an inexhaustible source of heat and light, of an intensity of which coal is not capable.
Today, hydrogen fuel cells do exactly that. While it's still more costly than pillaging the earth and polluting the global commons, hydrogen and oxygen can be extracted from water just by using electricity. So here, we rend apart the very structure of water to make hydrogen gas!
Materials
- Water
- Electricity (around 12 volts)
- Wire
- Pencils
- Pencil sharpener
- Tape
Make Electrodes
In our electrical setup, we will be using pencil leads as our electrodes (electrical contacts). Regular copper wire would corrode too fast to run our electrolysis machine very long. The carbon in pencil graphite is conductive, but will not corrode. To use the pencils as electrodes, sharpen both ends and expose the carbon graphite.
The hardest part of this experiment was finding a stupid pencil sharpener! How do I not own a pencil sharpener!?
Once sharpened, attach a wire to one end of each electrode. Wrap the wire tightly around the exposed graphite and tape it in place.
Duct tape works well for fixing the wires in place.
Connect Circuit
I'm using a wall power brick, but you could just as easily use a 12 volt solar panel or even two 9 volt batteries wired positive to negative. With no power connected, strip the wires from your power source and tape them to the other ends of the electrode.
I used a power jack with screw terminal connections I had laying around.
Just Add Water
Time to place your contraption in a container of water. If you want to capture the oxygen and hydrogen, you will need something to funnel the gasses into a bag or other container. I used juice bottles to direct my gasses into trash bags.
Cut a plastic bottle in half and tape your electrode so that it's suspended, centered in the bottle.
Cut some tiny holes in the sides of the bottle to allow water to flow between the two bottles.
Once both electrode funnels are made, tape a plastic bag over the top of each bottle.
Place your electrodes into a container of water so that the pencil tips are submerged.
Plug in your power source and watch the tips of the pencils under the water. Secure any exposed contacts to ensure that they do not fall into the water.
The electrodes will begin to form a tiny but steady stream of bubbles. The negative cathode will form hydrogen bubbles while the positive cathode will form oxygen. You can tell them apart by the volume of bubbles. Because water is composed of two hydrogen atoms and one oxygen atom, there are twice as many hydrogen bubbles being produced.
What uses can you come up with for this hydrogen/oxygen machine? I want to see how long it will take to collect enough hydrogen to lift a trash bag into the sky! Let us know what you would do with this project in our forum. Document with pictures and videos and post them up on the corkboard!
Main photo by theodoregray
Comments
No Comments Exist
Be the first, drop a comment!